From NewHaven Software Wiki

Revision as of 16:47, 9 January 2020 (view source) Russ horton (Talk | contribs) (→Prerequisite) ← Older edit		Revision as of 16:48, 9 January 2020 (view source) Russ horton (Talk | contribs) (→Workstation Install/Update) Newer edit →
Line 34:		Line 34:
	[[image:Workstation3.png]]		[[image:Workstation3.png]]
		+
		+	'''NOTE: There is no need to fill in the customer number and release code. Those are only needed for server installs.'''
	[[image:Workstation4.png]]		[[image:Workstation4.png]]

---

Revision as of 16:48, 9 January 2020

Contents 1 Overview 2 Prerequisite 2.1 Step 1: Workstation System Requirements 2.2 Step 2: Setup a mapped drive to the CMS server 2.3 Step 3: Obtain the CMS Installer 3 Workstation Install/Update

Overview

This article details the instructions for installing or updating a CMS 8, 9, or TEN Workstation.

Prerequisite

Before you begin installing or updating your workstation please check that you meet the requirements for all the steps below.

Step 1: Workstation System Requirements

To verify that your system meets CMS system requirements please review : http://wiki.newhavensoftware.com/index.php/CMS_System_Requirements#CMS_workstations

Step 2: Setup a mapped drive to the CMS server

Note: This is only needed if you are installing a new workstation. For Information on how to set up a mapped drive please review the video : http://youtu.be/D1IBcjWCmPs

Step 3: Obtain the CMS Installer

• Locate the last CMS update used, typically found in the \Updates subdirectory of the \NewHaven Software share (where you should now have a drive mapped to)

or

• visit http://updates.newhavensoftware.com/

For information on using the update page and downloading the installer please review the video : http://youtu.be/dBbd94k7b0A (Note: The video is focused on Windows XP, however, the setup steps are the same for Windows 7/10.

Workstation Install/Update

Note: The steps between updating or installing a CMS workstation are the same. Once you have verified that you meet the above prerequisites, follow the instructions below to Install/Update your workstation.

To begin double click the CMS installer, then follow the screenshots shown below.

NOTE: There is no need to fill in the customer number and release code. Those are only needed for server installs.

After following these instructions you should now be able to sign into CMS.